0x0D (Drive hardware error) on ML370 G4 X3.6GHz 2MB AP Rack Server

[gobi23]

Hi guys, need to replace the drive 0, with the status of Last Failure Reason: 0x14 (Drive removed from hot plug) on drive 1.

is it still ok to proceed to replace the disk?

would it require reboot?

Thanks

PHYSICAL DRIVE IDENTIFICATION:

   SCSI Port 1, Drive ID 0

      Vendor Id:           COMPAQ 

      Product Id:          BF0728A4CB     

      Product Rev:         HPB5

      Vendor Specific:     3KP448EL

      Serial Number:       XXXXXXXXXXXXXXXXXXX(for your security, I have removed the serial number from your post above - that's information you probably don't want to make publicly available.)

      SCSI Inquiry Header: 00 00 03 12 8b 00 01 3e

      Device Supports:     Tagged Command Queueing

                           Linked Commands

                           Synchronous Data Transfer

                           16-bit Wide Data Transfer

      Drive Type:          0x00 Parallel SCSI

      Block Size:          512 bytes/sector

      Total Blocks:        142255808 sectors/disk

      Reserved Blocks:     1088 reserved sectors/disk

      SCSI Inquiry Bits:   0x3E

      Stamped for M&P:     yes

      Last Failure Reason: 0x0D (Drive hardware error)

      Phys Drive Flags:    0xcd 0x25 0x9d 0x07

                           Drive present and operational

                           Wide SCSI transfers Enabled

SCSI Port 1, Drive ID 1

      Vendor Id:           COMPAQ 

      Product Id:          BF07289BC4     

      Product Rev:         HPB1

      Vendor Specific:     DNA1P6708S60

      Serial Number:       XXXXXXXXXXXXXXXXXXX(for your security, I have removed the serial number from your post above - that's information you probably don't want to make publicly available.)

      SCSI Inquiry Header: 00 00 03 12 5b 00 01 3a

      Device Supports:     Tagged Command Queueing

                           Linked Commands

                           Synchronous Data Transfer

                           16-bit Wide Data Transfer

      Drive Type:          0x00 Parallel SCSI

      Block Size:          512 bytes/sector

      Total Blocks:        142255808 sectors/disk

      Reserved Blocks:     1088 reserved sectors/disk

      SCSI Inquiry Bits:   0x3A

      Stamped for M&P:     yes

      Last Failure Reason: 0x14 (Drive removed from hot plug)

      Phys Drive Flags:    0xcd 0x25 0x9d 0x07

                           Drive present and operational

                           Wide SCSI transfers Enabled

                           Ultra320 SCSI Enabled

[Johan Guldmyr]

Hi,

is the drive listed as failed in ACU?
If it's not in a RAID0 it should be OK to replace it hot-swap.