HPE Community
ProLiant Servers (ML,DL,SL)
1825766 Members
2007 Online
109687 Solutions
New Discussion

2008 R2 Core Build NCU states additional Network Config Programs are active

 
garym_1
Occasional Contributor

‎05-11-2011 06:20 AM

‎05-11-2011 06:20 AM

2008 R2 Core Build NCU states additional Network Config Programs are active


Error during SCCM build of R2 Datacentre Core - installing the NCU often fails with error code 0xFFFFFFFD.

There are no other networking applications open (this is core and during build!) so not sure why this fails.

Exact error is : HP Network Configuration Utility installation cannot be done while network configuration programs are active. Please close all Network Property sheets and try again.

Appreciate any help with this
Cheers
0 Kudos
Reply
1 REPLY 1
Proliant VMS San Mgrs
Frequent Advisor

‎05-11-2011 11:41 AM

‎05-11-2011 11:41 AM

Re: 2008 R2 Core Build NCU states additional Network Config Programs are active

Garym,

What server? BIOS? ILO?
What network interface (LOM? which one)
What is the firmware on the network interface?
What version of NCU?

If all is up-to-date, then do what it says and wait until all network configurations (with property sheets open) have completed. I've never seen this happen myself. But, I've never installed core, either.
Problems Solved
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.