4-port sata raid controller - ml110g2

[fuetzi]

i have an 4-port sata raid controller with the spare 370013-001 with an adaptec aic8130 chip.
the controller doesn´t work on a ml11g2. i have installed the sata raid controller driver from ml150g2. HP ProLiant ML150 G2 Embedded SATA Controller Windows Driver, bute the controller doesn´t start (errorcode 10 on devicemanager).
is it possible to work on a ml110g2?

[Rajashekar Chintakunta]

Hi Fuetzi,

The Card should work fine on ML110G2 server also. Try the following driver and check if it works.

HP 4/8 Internal Port SAS HBA with RAID Driver for Windows Server 2003
http://h18007.www1.hp.com/support/files/storage/us/download/24682.html

Regards,
Raj.

[fuetzi]

hi Chintakunta,

i also install this driver, but this message is coming:
"The Software will not be installed on this System because the required hardware is not present or the software/firmware doesn´t apply to this system."
next, i exctract the file, and try to install by using the device manager. the same error on the devicemanager is display (errorcode 10)...cannot start the device...

[Michael Richter]

Spare should be 373013-001 instead of 370013-001 ... ?

the driver download page is the following
http://h18004.www1.hp.com/support/files/server/us/download/23061.html

Card should be plugged into Slot4

Please check additional with
HP SATA RAID Controller Manager for Windows
http://h18007.www1.hp.com/support/files/server/us/download/23531.html

Questions:
when u set up the Os u can successfully load the SATA Raid Driver via F6 into the OS Setup Routine!?