HPE Community
ProLiant Servers (ML,DL,SL)
1830044 Members
6717 Online
109998 Solutions
New Discussion

Compaq Smart Start - NT Terminal Server

 
Ayman Altounji
Valued Contributor

‎01-16-2001 04:00 PM

‎01-16-2001 04:00 PM

Compaq Smart Start - NT Terminal Server

How do I load NT 4.0 Terminal server when using Compaq Smart Start CD to configure My ML350.
John
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎02-13-2001 04:00 PM

‎02-13-2001 04:00 PM

Re: Compaq Smart Start - NT Terminal Server

In manual mode:

In order to install TSE on a system with a current Compaq SCSI controller, you need to create the 3 NT install disks from the NT TSE CD. Use the "WINNT /OX" command to do this. Then, when the Smartstart manual install is done, boot from those disks - without the NT CD in the drive until asked. Choose "custom" for the install mode (F6 key) and skip detection on mass storage. Specify an unlisted controller and use the Compaq NT 4.0 SSD for the drivers. Then specify a secondary controller and use the NT "IDE/Atapi" driver. You can also use the SSD for the NIC drivers (also likely to be out of date in NT).
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.