Controladora array P440AR

[PlusCompu]

Buenas tardes, tengo el siguiente problema acabo de conectar la controladora p440ar a mi servidor DL380 gen9, pero no me reconoce a la controladora, alguna sugerencia de lo que pueda probar.

**Google Translate**

Hello, I have the following problem about connecting the p440 controller to my DL380 gen9 server, but I don't recognize the controller, any advice on what you can try.

[Mamatha_J]

Hi @PlusCompu 

1. Make sure the SAS cable kit is the correct size for your chassis (e.g., 8 SFF or 12 LFF).
2. Reset the BIOS to restore the defaults and clear the NVRAM
3. Test 3 PCIe slots or swap cards
4. When all else fails, suspect hardware failure and try another controller
5. For accurate part numbers and setup guidance, use HPE QuickSpecs

Here's where you can find QuickSpecs
DL380 Gen9 QuickSpecs documents (available on HPE's website or product pages) list compatible controllers and cable kits. For ordering the right parts, these are essential references.
You can access them on HPE's support site by searching for "DL380 Gen9 QuickSpecs" or visiting the product page memory.

Thanks & Regards,

Mamatha

[support_s]

System recommended content:

1. HPE ProLiant DL388 Gen9 Server Maintenance and Service Guide

2. HP ProLiant DL388 Gen9 Server Maintenance and Service Guide (chm. file save to hard drive to view)

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.