Disable the standard array controller on DL380

[Dekker_3]

Hello,

We have a new Proliant DL380 with standard an 5i Araay controller in it. We bought an other (better ofcourse) controller for it. Now we have a dillemma...

How can we disable the standard array in favor of the new one?
(We found that we can disable the IRQ, but that is not really the best way in our vision)

Thanks in advance for reply's!
Marc Dekker
Hotelplan B.V.

[Arco van Pieterson]

That is the same question as i asked.

[Tom Mucha_1]

You can check the other message I just posted, but I'll paste it in here.....


When you boot, go into the F9 RBSU. Under advanced options, there is a selection for F1 boot delay (not sure about the correct wording). You can change the setting to Delay which will put up the F1 option, but then go away, or disable it tottally so the F1 message doesn't even show up. I personally would stick with the Delay option.