DL 380 G3 NMI parity error with W2k3

[Stefano Giusto_1]

Just installed a DL 380 G3
W2k3 is on and works fine
done forest preparation to installa exchange server 2003
leaved the server running last night
this morning server was on blue screen with nmi error
now every boot shows the nmi error
RAM is OK
W2k3 starts correctly in safe mode
All bios and drivers up to date

[Rob Leadbeater]

Hi,

What's the exact error message of the blue screen ?

I've been getting what sounds like a similar fault on a BL20p G2. The machine ran fine with just the OS installed, but then started crashing when it had some load, in my case with Citrix Metaframe. I can't remember the exact error, but I know it had NMI in it somewhere...

I'll post again, when I get to the office.

Rob

[FRED JEWELL JR]

If its a memory parity error and the memory checks out. It could be your controler card, are you using the 5I + . I had some memory issues with it, the 5I+ does have some memory on it.

Good Luck

[Stefano Giusto_1]

HP Replaced the mainboard of DL380 and all is ok now.
This thread is over
thanks all