DL20 install OS on M.2 NVME

[marcellinus]

Hi

I have a new DL20 GEN10 Server and installed an internal M.2 NVME Drive. The drive is shown in BIOS and in SmartStorage Administrator.

How can I install an operatin system on this NVME? It does not show up in Intelligent Provisioning.

Any help is apreciated!

Kind regards

Marcellinus

[sudhirsingh · Accepted solution]

Hi,

M.2 drives are managed through software raid (S100i), 

I believe you need to boot with OS media directly and install Operating system.

You may need to provide S100i driver incase drive does not detect while booting with OS Media.

S100i driver:

https://support.hpe.com/hpsc/swd/public/detail?swItemId=MTX_5b8eac1a8fe144b4ae4f537c75#tab-history

If you feel this was helpful please click the KUDOS! thumb below!

Regards,

Sudhir

[marcellinus]

Hi

thank you for the reply. I just found out that it worked to install booting from the Installation Media. However, this was confusing as I normally provision all servers with Intelligent Provisioning and not booting from installation media directly.

Kind regards

Marcellinus

[MadsHaugaard]

Hello @marcellinus 

How did you solve this issue?

I'm having problems booting to USB drive, with the OS install media.
Choosing "One-Time boot menu" does not work with UEFI, and enabeling Legacy mode works but disables the option to install to NVME because it disables SW raid.
What do I do?

[mysy]

I think he talk about m.2 NVME SSD card, not m.2 SATA SSD card  ,the m.2 slot. Not the sata one. I read it was PCIE device ,not use S100i to control.

[MadsHaugaard]

Well i figures it out anyways.
I had problems installing on the onboard M.2 slot. (The one where you also can install a dedicated iLO expansion board.
But I figured it out, reformatting my USB install media to FAT32 and making in able to install in UEFI.

Now the only problem I have is that the fans run 100% no matter what, and I haven’t figured out yet what to do about that.

Med venlig hilsen

Mads Haugaard

[mysy]

I have the install nvme card and fans run 85% issue too...

[MadsHaugaard]

Do you have The dedicated iLO port/nvme expansion installed?

[mysy]

I install the nvme SSD to mainboard m.2 slot directly. My DL20 don't have the dedicated iLO module.

[MadsHaugaard]

@marcellinus 

What drive did you use?
Did you install it in the M.2 NVMe slot directly or did you use the dedicated iLO/Serial/M.2 card?
Does your fans run at 100%?

[TechWryte]

Hi Mads

If you could elaborate a little more on the M.2 NVME ILO slot install. I have a similar problem.

When the o/s boots up from the usb to install, I do not see the M.2 NVME drive at all

It would be great if you have any pointers - any drivers to be installed to see the M.2 NVME drive for the o/s to see?

Thanks in advance

Krishna

[Barryn]

I have also installed a Kingston 2TB Gen3 NVMe M.2, it is recognised by the BIOS, but not by the storage administrator and does not come up in the device manager. Have searched the site but do not see a solution?