HPE Community
ProLiant Servers (ML,DL,SL)
1847797 Members
3365 Online
104021 Solutions
New Discussion

DL360 G5 Raid Setup

 
MP155
New Member

‎03-20-2009 05:46 AM

‎03-20-2009 05:46 AM

DL360 G5 Raid Setup

Hi All,
how would i configure the array in a DL360 G5 server with 4 72GB drives, requirement being 2 RAID 1 sets (set 1 and 2 both contain 2 x 72Gb drives mirrored).
Basically if I lost one drive in each array, the server would still run.

Thanks in advance.
0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎03-20-2009 05:59 AM

‎03-20-2009 05:59 AM

Re: DL360 G5 Raid Setup

You are in the hp-ux area, but you don't use hp-ux for sure.

You did not tell what you want to run on your proliant.

Anyway, boot the smartstart CD and configure your array.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Steven E. Protter
Exalted Contributor

‎03-20-2009 06:02 AM

‎03-20-2009 06:02 AM

Re: DL360 G5 Raid Setup

Shalom,

If this server has the P400 smart raid card installed, you can interrupt the boot and set up raid with te bio based utility.

The prompt is obvious, probably F8 at the console and the utility is very straightforward.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.