DL360 G8 FBWC モジュール LED

[ともひろ]

FBWC モジュール LEDでは、「前回または今回の起動時に、電源エラーが発生しました。データが壊れている可能性があります。」この内容対応方法は、何を参照すれば良いのでしょうか？

Google Translated: 

DL360 G8 FBWC module LED
The FBWC module LED says "A power error occurred during the previous or current boot. Data may be corrupted."

[TVVJ]

Hello,

As the error message states that there was a power error, ensure that there is no data loss and create backups as necessary.

Regards,

[ともひろ]

@TVVJ 

Array　batteryの交換で治ったりしませんか？

Google Translated: 

Wouldn't it be possible to fix it by replacing the array battery?

[Vinky_99]

@ともひろ 

Good day! 

Yes, replacing the array battery is a potential solution to address the power error and data corruption message related to the FBWC (Flash-Backed Write Cache) module LED on an HP ProLiant DL360 G8 server. The array battery provides backup power to the FBWC module, ensuring that data is written to the cache during power interruptions.

However, before that you can give it a try below ones:

>> Turn off the server, unplug the power cords, and wait for a few minutes. Then, reconnect the power cords and turn on the server again.
>> Ensure that all power cables are securely connected to the server and power source. Check for any loose or damaged power cables, and replace them if necessary.
>> The DL360 G8 server usually has redundant power supplies. Check the status of the power supply LEDs to ensure they are functioning correctly. If any power supply has a fault, it should be replaced.
>> Make sure you have the latest firmware installed for the server's components, including the FBWC module.
>> try using a different FBWC module to see if the issue persists.

I hope this helps! Let me know...