DL380 G6 with P410i array controller

[Benjamin Hay]

I am not seeing a bootable drive? Tried Using SmartStart 8.25 and 8.20, created raid 1 and logical drive is detected by the controller card during post and ACU gui. When I continue to deployment of the server, no bootable drive. I am using Firmware 8.50 and no updates are available. Any thoughts would be greatly appreciated. I have Two DL380 G6's with the same behavior. I also have DL360 G6 with the same array controller and no issues what so ever.

[Patrick Terlisten]

Hello,

check the controller order in the RBSU. Did the installation if the OS finished?

Best regards,
Patrick

[MDS-ALPA]

Would be good to take a look at the thread below:

DL380 G6 OS Load method
http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=1395648

Mark