HPE Community
ProLiant Servers (ML,DL,SL)
1834674 Members
2224 Online
110069 Solutions
New Discussion

DL380 Gen6 : EventID:1204 Drive Array Accelerator Status Change.

 
dlwnsgh
Occasional Contributor

‎07-23-2017 07:56 PM - edited ‎07-23-2017 08:28 PM

‎07-23-2017 07:56 PM - edited ‎07-23-2017 08:28 PM

DL380 Gen6 : EventID:1204 Drive Array Accelerator Status Change.

Hello Guys,

 

I have a DL380 Gen6 server. In the event log on windows server(x86), I can see the 1204 messages as below.

 

EventID:1204 Detail:Drive Array Accelerator Status Change. The array accelerator board attached to the array controller in Slot 0 has a new status of 4. (Accelerator status values: 1=other, 2=notConfigured, 3=enabled, 4=tmpDisabled, 5=permDisabled) [SNMP TRAP: 3038 in CPQIDA.MIB]

 EventID:1204 Detail:Drive Array Accelerator Status Change. The array accelerator board attached to the array controller in Slot 0 has a new status of 3. (Accelerator status values: 1=other, 2=notConfigured, 3=enabled, 4=tmpDisabled, 5=permDisabled) [SNMP TRAP: 3038 in CPQIDA.MIB]

 

According my googling, the event can be sloved after firmware upgrade or replacing a battery.

I'm not sure that is correct. if you have a solution, please let me know.

 

Thanks.

 

 

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.