HPE Community
ProLiant Servers (ML,DL,SL)
1755643 Members
3363 Online
108837 Solutions
New Discussion юеВ

DL580 G2 iLo enabling issue

 
Tero L├дhteenm├дki
New Member

тАО05-14-2006 11:43 PM

тАО05-14-2006 11:43 PM

DL580 G2 iLo enabling issue

Hi,

'iLO ROM based setup utility' is currently in disabled mode and I cannot configure the iLO setup. How can it be enabled?

-t
0 Kudos
Reply
2 REPLIES 2
Andrzej Kowalik
Honored Contributor

тАО05-15-2006 12:14 AM

тАО05-15-2006 12:14 AM

Re: DL580 G2 iLo enabling issue

Press F8 key during startup (iLO) process - even if you can not see such command\prompt

regards,
Andrzej Kowalik
0 Kudos
Reply
Dmitry_75
Valued Contributor

тАО05-18-2006 08:57 PM

тАО05-18-2006 08:57 PM

Re: DL580 G2 iLo enabling issue

Hi!
You can turn on iLO/Spread Spectrum Switch (SW8) position 1 iLO security override, The override allows the administrator full access to the iLO processor.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.