HPE Community
ProLiant Servers (ML,DL,SL)
1758347 Members
2018 Online
108868 Solutions
New Discussion юеВ

Re: DL785 G6 only sees Proc/mem cell 8

 
Saberus
Valued Contributor

тАО03-08-2010 05:29 PM

тАО03-08-2010 05:29 PM

DL785 G6 only sees Proc/mem cell 8

I am have 4 785тАЩs that have been running into issues when they are powered up or powercycled.

They only register proc/mem cell 8. The current work around I have found is to power off the server, reseat cell 8, power the server back on and wait.

The servers will run for several minutes at full fans before performing a prepost memory check as if new memory was installed.

I have updated the firmware to the latest available (BIOS/RBSU 12.04.2009 and iLO2 1.81) and am still encountering this issue.

I have searched the HP forums and have found no similar incidents. I am creating a thread on the forums to probe if anyone else has found a more suitable work around.

Sitting by a cluster and reseating/resetting 4 servers until they see all their processors and memory is kludgy at best.
0 Kudos
2 REPLIES 2
Saberus
Valued Contributor

тАО03-09-2010 02:06 PM

тАО03-09-2010 02:06 PM

Re: DL785 G6 only sees Proc/mem cell 8

I was able to isolate the problem. The midplane on the server was faulty.
0 Kudos
Saberus
Valued Contributor

тАО03-09-2010 02:06 PM

тАО03-09-2010 02:06 PM

Re: DL785 G6 only sees Proc/mem cell 8

Closing thread.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.