Does RDP 6.1 SP2 support the ML570 G3 P600 array controller?

[Eric Meiring]

Hello,
I am trying to capture the array configuration from an HP Proliant ML570 G3 with the P600 array controller using 2.5" SAS drives. The rest of my image/HW capture went fine, but the job seems to skip the array config capture every time.

In looking deeper, I see that one of the script files that comes with RDP, SSSTKARR.INI specifies a list of HP array controllers to use, but the P600 is not listed. Is it safe to assume that I am SOL and cannot perform this array capture with my RDP version (6.1, SP2), or is there a workaround?

HP's RDP knowledge base doesn't mention it specifically, but it does mention that serial ATA is not supported for this - perhaps the same goes for serial SCSI (SAS).

Thanks!