HPE Community
ProLiant Servers (ML,DL,SL)
1833764 Members
1984 Online
110063 Solutions
New Discussion

Drive LEDs non-functional

 
Ayman Altounji
Valued Contributor

‎10-14-2001 04:00 PM

‎10-14-2001 04:00 PM

Drive LEDs non-functional

We have a ML530 which has 6 36gig drives in it. Under normal operation, the drives show a green colored cylinder LED that remains lit all the time. When the drives are accessed (read/write), then a little green arrow LED flashes on/off. Also, when you go into the array manager, there is a green cylinder with a red X LED that shows up, to tell you that you are accessing the drives through the array manager. The Arrow LED is the only one to work, the two cylinder LEDs on all drives do not work. Why are my drive lights not working anymore. FYI... there are no messages in the event log that show me any failure and the diskmanager shows healthy drives/volumes etc. What gives?

TIA... Mitchell
0 Kudos
Reply
1 REPLY 1
Mark Cloutier
Respected Contributor

‎11-26-2001 04:00 PM

‎11-26-2001 04:00 PM

Re: Drive LEDs non-functional

the led's are given their info through a pinout on the scsi cable..check cables and replace if necessary..also cehck the connectors to see for bent pins
We are here for a good time, not a long time!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.