HPE Community
ProLiant Servers (ML,DL,SL)
1848685 Members
7139 Online
104035 Solutions
New Discussion

Error with Suport Pack 7.30

 
George McCullen_1
Occasional Advisor

‎05-19-2005 02:18 AM

‎05-19-2005 02:18 AM

Error with Suport Pack 7.30

I get the following error when I run bp000233.cmd on a DL360G4 (this is fresh server build running 2003). It happens at the same point each time, the last thing that happens is the echo statement for echo Installing HP NC10xx/67xx/77xx/150x/320x Gigabit Ethernet NIC Driver for Windows Server 2003 ... then I get this message.

"The System cannot open the device or file specified."

Afetr a reboot I ran the support pack again and it worked fine. I also check the log and the last thing in the list is a succeful install of the NC10xx/.... driver.
0 Kudos
Reply
1 REPLY 1
Jonathan_111
New Member

‎05-24-2005 07:23 AM

‎05-24-2005 07:23 AM

Re: Error with Suport Pack 7.30

Have you tried re-downloading that file then rerunning the installation?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.