HPE Community
ProLiant Servers (ML,DL,SL)
1833764 Members
2713 Online
110063 Solutions
New Discussion

HARD DISK NEW BUT STILL RED LIGHT

 
Ayman Altounji
Valued Contributor

‎01-10-2001 04:00 PM

‎01-10-2001 04:00 PM

HARD DISK NEW BUT STILL RED LIGHT

Running hardware mirror and replaced reported failed disk.
Still showing red light.

Ta
0 Kudos
Reply
3 REPLIES 3
Ayman Altounji
Valued Contributor

‎01-31-2001 04:00 PM

‎01-31-2001 04:00 PM

Re: HARD DISK NEW BUT STILL RED LIGHT

What drives? What controller? How do you have them attached?
0 Kudos
Reply
Ayman Altounji
Valued Contributor

‎10-07-2001 04:00 PM

‎10-07-2001 04:00 PM

Re: HARD DISK NEW BUT STILL RED LIGHT

I have a similar problem; 1850R with 3200 Array controller w/ 2x 9.1GB drives in RAID1 config. The drive in slot 0 has failed at what appears to be random occasions and I have replaced it each time. I had a Compaq engineer out to have a look at it, but all he did was change the array controller. The drive failed again this weekend after about one month of no problems. I am beginning to suspect SCSI issues with the drive in Slot1.

Any one have any ideas?
0 Kudos
Reply
Ayman Altounji
Valued Contributor

‎09-08-2002 04:00 PM

‎09-08-2002 04:00 PM

Re: HARD DISK NEW BUT STILL RED LIGHT

I believe that if you upgrade the firmware of the controller that it fixes this issue...

As i had a similar one, that caused compaq to create the same scenario, that was their resolve
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.