HPE Community
ProLiant Servers (ML,DL,SL)
1830730 Members
1998 Online
110015 Solutions
New Discussion

How to add 2nd E200 controller to ML350 G5?

 
Solarbuddy
Occasional Contributor

‎05-28-2010 03:32 PM - edited ‎05-28-2010 04:41 PM

‎05-28-2010 03:32 PM - edited ‎05-28-2010 04:41 PM

How to add 2nd E200 controller to ML350 G5?

I need just a few more drives in a system already maxed out with 8 SAS drives in the 2 1/2" cage.   I was thinking of adding a few SATA drives to the 5" bays and then just hooking them up to the simplest HP controller I could find.  The E200 sounds very compatible, but I can't figure out what cable assembly I would need.  It would need to run from the special connector on the E200 card and end in standard SATA cables so I could plug in the drives.  Any suggestions?

 

Later:  I found a few references to these cables (389950-001, 389653-B21) -- are these what I'm looking for?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.