How to configure ilo on ML110 G6

[abacabb]

Does anyone know how to configure the ILO on the ProLiant ML110 G6? I tried searching for documents and was not successful.

[Johan Guldmyr]

Hey, on the G6 the integrated iLO is a HP "Lights-Out 100i".

More info about it can be found here: http://www.hp.com/go/lo100

Usually you configure this by pressing the right button at the right time during POST/boot of the server. Often it is F8.

[Yaning.Wu]

When POST,press F10 to enter BIOS--Advanced---IPMI--LAN SETTINGS,Then you can set the IP address

[Priyansha]

Hi,

To configur iLO you can go through the following HP guided troubleshooting link :

Under Management and Monitorining u will find iLO :

http://h20584.www2.hp.com/hpgt/guides/select?lang=en&cc=us&prodTypeId=15351&prodSeriesId=3984625&lang=en&cc=us

[Lincy_Zachariah]

Hi,

Steps to configure lights out 100 : Configuring network access: Through your server network connection, you can access the remote management CLP, verify POST (power-on self test) remotely, access the server through a web browser, and access the BIOS Setup Utility remotely. To configure network access: 1. Connect a standard Ethernet cable from the LO100 NICto a network jack. 2. Press the F10 key to access BIOS. 3. Obtain the DHCP IP address. o For ML110 G6: i. Press the right arrow → key to scroll to the Advanced tab, and then scroll down to IPMI. Press the Enter key. ii. Click LAN Settings, and then click Set IP Address Assignment to DHCP. Obtain the IP address from BIOS Setup Utility under Advanced/IPMI Configuration/LAN Configuration.

Click here for HP ProLiant Lights Out-100 User Guide

You can access HPGT to get step by step solution:
Clcik here for HOGT on HP Proliant ML110 G6
Select - Configuration and Setup --> HP Lights-Out 100 (LO100) Configuration

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02063205/c02063205.pdf

[Sirajul_Haque]

Hi, 

Step by step instructions to configure HP Lights-Out 100 (LO100) is available at below said link:

Guide: How to Configure HP Lights-Out 100 (LO100)

It may be helpful to you.

Regards