hrconf ML110G4

[penr]

Hi, i have a proliant ml110 g4, operating system linux, with utility hrconf i can see a task in progress, blocked from 3 days, can i kill this task?

Controllers found: 1
Logical drive Task:
Logical drive : 1
Current operation : Verify
Status : In Progress
Percentage complete : 41

This command does not work, hrconf TASK STOP 1 LOGICALDRIVE 1, the error is "The requested action has timed out"

printout of hrconf getconfig 1
Controllers found: 1

----------------------------------------------------------------------
Controller information
----------------------------------------------------------------------
Controller Status : OK
Channel description : SATA
Defunct disk drive count : 0
Logical drives/Failed/Degraded : 1/0/0

----------------------------------------------------------------------
Logical drive information
----------------------------------------------------------------------
Logical drive number 1
Logical drive name : raid1
Status of logical drive : Optimal
RAID level : 1
Size : 152459 MB
Number of chunks : 2
Drive(s) (Channel,Device) : 0,1 0,2

----------------------------------------------------------------------
Physical device information
----------------------------------------------------------------------
Channel #0:
Transfer Speed : SATA 3.0 Gb/s
Device #1
Device is a Hard drive
State : Online
Transfer Speed : SATA 1.5 Gb/s
Vendor : WDC
Model : WD1600JS-70SGB
Firmware : 6C06
Serial number : WD-WCAP02623285
Size : 152587 MB
Write Cache : Disabled (write-through)
FRU : none
S.M.A.R.T. : No
Device #2
Device is a Hard drive
State : Online
Transfer Speed : SATA 1.5 Gb/s
Vendor : FB160C40
Model : 81
Firmware : HPF0
Serial number : 6RX128NE
Size : 152587 MB
Write Cache : Disabled (write-through)
FRU : none
S.M.A.R.T. : No


Command completed successfully.