- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Re: iLO Security Switch Missing on Motherboard
ProLiant Servers (ML,DL,SL)
1764024
Members
2175
Online
108921
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-20-2010 12:11 PM
09-20-2010 12:11 PM
iLO Security Switch Missing on Motherboard
Have two DL380 G6.
Where is system maintenance switch on the motherboard? See battery and NMI jumper next to battery but no maintenance switch next to NMI jumper. Cover says switch should be there and so does manual. Can not configure iLo until switch setting is changed to enable iLo changes. There is literally no switch soldered into the board. Attempting to change setup on boot does not work.
Where is system maintenance switch on the motherboard? See battery and NMI jumper next to battery but no maintenance switch next to NMI jumper. Cover says switch should be there and so does manual. Can not configure iLo until switch setting is changed to enable iLo changes. There is literally no switch soldered into the board. Attempting to change setup on boot does not work.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-20-2010 12:13 PM
09-20-2010 12:13 PM
Re: iLO Security Switch Missing on Motherboard
Found it -- see attached picture. Documentation needs adjusting for blinder (older) folks.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP