Intelligent provisioning DL320 gen11 MR408i-o Rapid Setup can't apply recomended array set

[xaviermn]

On new DL320 Gen11 server with MR408i-o when we go on Intelligent Provisioning and doing an Rapid Setup we see the message:

The server has 4 SSD disks and we want 2 Raid 1 logical volumen. The recogonises properly the controller and the 4 phisical disks. I CONTINUE the RAPID SETUP I see:

I think the rapid setup is selecting one physical disk.
How we can proceed ? What is the rigtht way ? Going F9 Config an trying to create de two Raid1 from then MR controller menu, or updating the Intelligent provisioning to permit Rapid Setup applying recomended array settings on MR408

Thank you in advance.

[TVVJ · Accepted solution]

Hello,

The enhancement included in version 4.31 of the "Intelligent Provisioning Recovery Media for Gen11" indicates that HPE MR storage controllers are supported for array configuration and OS installation.

Hence please install the update from the above link.

After performing the update, please use Intelligent Provisioning to perform the installation to check if the issue is resolved.

If the issue persists, then restart the server, press the key "F9" during POST prompt to launch the UEFI System Utilities. On the System Utilities page, select the HPE MegaRAID controller and then continue to configure the array and install the operating system on the detected logical drive.

Regards,

[xaviermn]

For applying the update, I understand that I can do it mounting the Iso file from Ilo Advcanced, and booting from virtual DVD, it's right ?

[TVVJ]

Hello,

Yes, you may do so.

Regards,