HPE Community
ProLiant Servers (ML,DL,SL)
1827288 Members
1629 Online
109717 Solutions
New Discussion

ML150G3 AND THIRD PARTY SIMPLE SATA DRIVES

 
Christos Goulas
Advisor

‎06-02-2008 07:13 PM

‎06-02-2008 07:13 PM

ML150G3 AND THIRD PARTY SIMPLE SATA DRIVES

Hi,

has anyone ever successfully fitted a third party sata hdd into an ml-150g3 (470064-472)? I found part number (373211-001)on the internet and was wondering if that is possible. If it is possible do I need a special kind of Sata drive or anyone would do? Do I also need any special cables to fit or just a normal sata cable would do?

Thank you for your time,

Christos
0 Kudos
Reply
1 REPLY 1
Mark Chimes
Occasional Advisor

‎06-12-2008 03:31 AM

‎06-12-2008 03:31 AM

Re: ML150G3 AND THIRD PARTY SIMPLE SATA DRIVES

Hi Christos,

Hmmm. Not sure.

I just installed two SATA HDDs into an ML350G5. One was a Seagate and one was a Western Digital. They came from HP, but they look like standard SATA units to me.

If you buy from a non-HP source then you will have to obtain the drive chassis unless you already have them.

Apart from that I am not sure of the setup of the ML150 G3. Does it have HOT swap drive bays?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.