Ml310 RAID 1 config problems

[Craig_79]

I can't seem to get disk 1 to show in Disk manager of Win2000. Integrated Dual Channel Ultra-ATA-100 with integrated RAID 1 with 80gig hds. I ran the integrated Raid util (f8) at before install. After install I only see Disk 0, not disk 1. I have done this twice. Installed OS with Smart Start. I am now thinking that I haven't setup the array correctly somewhere. Do I need disk 0 dynamic with this raid card? I know I do for software raid. Thanks

[Martin Breidenbach]

If you configured hardware RAID 1 then the operating system should see only one logical drive.

At least that is how it works with every other hardware RAID controller that I've seen - I don't have direct experience with the ML310.