NIC Team while does not work

[Ayman Altounji]

I have a DL 380, using two NC6134 1000Mb cards that are teamed. I cannot get them to work in a load balanced configuration of any description, only fault tollerant. I used Smart Start 4.9 to configure them. The comminucations may work for a while load balanced, but then the server may not be seen on the network, but the server can brows the network. It might be viceversa. Does anybody have any ideas??

dwight maddox dmaddoxjr@ridetarc.org

[Ayman Altounji]

I have a ML370 with two NC6134s. Again I am unable to team up the NICs for load balancing. The server just blue screen on reboot. However I teamed up the cards 'under network properties,NT4) It does the same even for teaming with fault tolerance. When you finally find a solution - I'd be very interested.

[Ayman Altounji]

I called Cisco on mine, they said they only support Fast Etherchannel with port grouping