HPE Community
ProLiant Servers (ML,DL,SL)
1823949 Members
3563 Online
109667 Solutions
New Discussion

Poliant ML110 do not start after unproper shutdown

 
CGarnier
Occasional Visitor

‎08-02-2011 10:14 AM

‎08-02-2011 10:14 AM

Poliant ML110 do not start after unproper shutdown

I have a HP Proliant ML110 that could not start properly after a electricity blackout. The external LED's are green but, the mainbord has three lights: gree, red and green. I found this document: http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00795605/c00795605.pdf?jumpid=reg_R1002_USEN on page 61/69 show the layout of the mainboard. The light that is RED is the number two. I was looking for the way to find a troubleshooting for this server, but I couldn't anything that helps. The server doesn't have video. I removed all additional card, disconnect the HDD, change the RAM from slot and try two different dimm RAM in each slot.

 

Nothing work. Does anyone have a recommedation?

0 Kudos
Reply
1 REPLY 1
Robert Egloff
Frequent Advisor

‎08-02-2011 11:23 AM

‎08-02-2011 11:23 AM

Re: Poliant ML110 do not start after unproper shutdown

Hmm - I had a similar issue once...

 

Right after a power outage also - try pulling one of the CPU's and see if it will boot. Then swap them, and try the other. I don't recall if you need to pull the voltage regulator too for that specific CPU, but I would. Anyone else know offhand on that?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.