Problem with array P212 (ML370G6, Solaris10)

[o_robert]

I have server ML370G6 and  array controler P212. I install Solaris 10, update driver and firmware, but Solaris not configuring P212. To array 212 is connected only DAT160 SAS.

cfgadm -al show:

c2 scsi-bus connected unconfigured unknown

I configure controler 2:

cfgadm -c configure c2 

but not working.

Can anybody help me ?

[Johan Guldmyr]

Hi, shouldn't you be using hp's tools to configure the controller? (now I've never run solaris10 nor this hw).

Have you added drivers from http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=3890396&lang=en&cc=us&taskId=135&prodTypeId=329290&prodSeriesId=3885791

?

[o_robert]

Drivers for P212 (for Solaris) is the same for P410 (built-in server). Driver was loaded in installation process.

HP Tools (for Solaris) not visible controller

[Suman_1978]

Hi,

If the controller itself is not visible, did you check if the controller is detected during POST/RBSU.

Have you tried to install controller into different slot and test.

Here is an interesting advisory.

For the HP ProLiant ML370 G6 server, built before April 8, 2009 (04/08/2009), install the controller in Slot 6, Slot 3, or Slot 8. For the best server performance, Slot 6 is the preferred slot, followed by Slot 3 then Slot 8.

Good Luck!

Thank You!
__________________________________________
Was the post useful? Click on the white KUDOS! Star.

For product specific Guided Troubleshooting visit; http://www.hp.com/support/hpgt
Want to know How to use HP Guided Troubleshooting?  Visit the below link.
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c03283214

[Silicio]

Hi,

Could you resolve this issue?

I'm trying to configure a LTO4 through a P212 controller ina Proliant with Solaris 10.

Any help will be appreciated.

Regards,

Silicio