HPE Community
ProLiant Servers (ML,DL,SL)
1845589 Members
2855 Online
110246 Solutions
New Discussion

Proliant 2500 not correctly detecting switch #6

 
Ian Girvan
New Member

‎08-06-2003 12:22 AM

‎08-06-2003 12:22 AM

Proliant 2500 not correctly detecting switch #6

Having problem when using the configuration utility. Everything looks fine from boot up till after second DOS screen then I get an error message: "Error during boot. The maintenance jumper (typically switch #6 or Jumper e17) is set. If you are booting a floppy, you may press Enter to continue, but some configuration inform. cannot be read or set. If booting from CD, you must set maintenance jumper to the default setting and reboot."
I've tried switch #6 on bank SW1 both ON and OFF without success. The utility still sees the switch as set. Has anybody seen this issue before?

Thanks.
0 Kudos
Reply
1 REPLY 1
Ian Girvan
New Member

‎08-26-2003 02:53 PM

‎08-26-2003 02:53 PM

Re: Proliant 2500 not correctly detecting switch #6

Just to follow up...
Seems like this was a hardware fault, as replacing the system board resolved the issue.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.