Proliant 5000 214-IO Board, power module 2 Failed

[David_962]

Hi,

I recieve the message '214-IO Board, power module 2 Failed' when my Proliant 5000 is doing the post test. I have updated the system om to the latest version about 2 days ago (E6 o4/30/99). In the log it says DC-DC converter failure. Anyone know how to cure this? Will it need a hardware part or does it just need resetting?

Config:

4 x Pentium Pro's / 650mb Ram 4x 4.3 HD 2/P Samrt Array controller (4.5 firmware).

Thanks!

[Oleg Koroz]

Look over pictures and swap around A with B
Access to F10 over POST and Run System Configuration see if that help you

http://partsurfer.hp.com/cgi-bin/spi/showphoto?partnumber=296203-001

http://partsurfer.hp.com/cgi-bin/spi/showphoto?partnumber=219209-001

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00398113
Item 26

[David_962]

Thanks for the reply. I powered down the system for over 8 hours and the message has dissapeared? I assume the excess voltage run down on its own. Thank you for the info - i'll look into this board if it comes up again!