HPE Community
ProLiant Servers (ML,DL,SL)
1825771 Members
2156 Online
109687 Solutions
New Discussion

Proliant ml350 g3

 
John Bianco
Occasional Contributor

‎11-21-2006 05:34 AM

‎11-21-2006 05:34 AM

Proliant ml350 g3

Thought to have a bad power supply in slot 2.(No power) Replaced it with a new one. Powered up system with the old one in slot 1,new one in slot 2. powered on. Waited a few minutes, and still nothing with the new PS.Old one still works. Powered down server. Swapped power supplies,Both came up,but the new one now in slot 1 is blinking on and off,and then dies. Put old power supply back into slot 1 powers up no problem. Could the new power supply be bad? Is there anything that I have to do to clear the fault?
0 Kudos
Reply
1 REPLY 1
Daniel Leblanc
Honored Contributor

‎11-22-2006 03:45 AM

‎11-22-2006 03:45 AM

Re: Proliant ml350 g3

You should be able to put default in the bios, but i don't think that would resolve you're problem,make HP take it back has DOA the PS.

Dan
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.