Questions about installing MR Storage Administrator on ubuntu 22.04

[jmwoo]

hello. Good to see you.

I have a DL380 G10 plus with MR series controller and installed ubuntu 22.04.
SPP seems to install only on redhat, centos and rocky but not on ubuntu.
The reason I want to install SPP is to install SSA, which I understand has been changed to something called MR Storage Administrator on MR series controllers.
I have searched for MR Storage Administrator on the hpe site, but can't find any software for ubuntu.
Is there any way to install ubuntu 22.04 on a DL380 G10 plus model and install MR Storage Administrator?

Thank you for your reply.

[TVVJ]

Hello,

You may download the following version of MRSA

HPE MegaRAID Storage Administrator for Linux 64-bit (HPE MRSA for Gen10 Plus and Gen11 Controllers)

HPE MegaRAID Storage Administrator for Linux 64-bit (HPE MRSA for Gen10/Gen10 Plus Controllers)

Regards,

[jmwoo]

Thank you for your response.

I don't see ubuntu in the list of supported OS in that link, is it available?
If it can be installed on ubuntu, what is the command to run the gui environment?
In the existing SSA, I ran the GUI environment with ssa -local.

[TVVJ]

Hello,

Please try installing "HPE MegaRAID Storage Administrator StorCLI for Linux 64-bit (for Gen10 and Gen10 Plus Controllers)". StorCLI is a command line interface for managing HPE MegaRAID Controllers.

Please refer to section "2.2 Installing the StorCLI Tool on Linux Operating Systems" on page 10 of the HPE StorCLI User Guide for installing StorCLI on Linux systems.

Regards,

[jmwoo]

Thank you for your response.

Isn't GUI environment supported other than CLI environment? I want to use it as a GUI.

[Harshitha_K]

Hi @jmwoo ,

Please find the link below for MRSA for windows (GUI)

HPE MegaRAID Storage Administrator for Windows 64-bit (HPE MRSA for Gen10 Plus and Gen11 Controllers)

Here are the some of the videos on MegaRAID Storage Administrator

Thank you!

[jmwoo]

Thanks for all the above answers.

Ubuntu does not seem to have a GUI environment.
When I enter the StartupLSAUI.sh command, it doesn't respond.
I think I need to check the raid status in iLo or CLI mode first.