HPE Community
ProLiant Servers (ML,DL,SL)
1849933 Members
3937 Online
104049 Solutions
New Discussion

Re: RAID 5 Array

 
Ayman Altounji
Valued Contributor

‎01-28-2001 04:00 PM

‎01-28-2001 04:00 PM

RAID 5 Array

I have recently fitted a new HD into a Smart2-DH array. Logical Drive 1 will not rebuild, even after applying all latest firmware. I have tried another HD, still no joy. ACU reports that the HD in Slot 0 (not the one replaced) has exceeded it's threshold for errors. Do I need to rebuild the array from scratch or can I replace the drive in Slot 0 (bearing in mind the logical drive 1 is not rebuilt).
0 Kudos
Reply
3 REPLIES 3
Ayman Altounji
Valued Contributor

‎01-28-2001 04:00 PM

‎01-28-2001 04:00 PM

Re: RAID 5 Array

I've run into this before. If you are replacing a bad hd & another one in the raid 5 array is bad enough that array diagnostic is showing too many errors then you will have to replace both drives & restore from backup.
0 Kudos
Reply
Ayman Altounji
Valued Contributor

‎01-29-2001 04:00 PM

‎01-29-2001 04:00 PM

Re: RAID 5 Array

Thanx
0 Kudos
Reply
Ayman Altounji
Valued Contributor

‎02-12-2001 04:00 PM

‎02-12-2001 04:00 PM

Re: RAID 5 Array

Thanks for the correct answer - If you're still seeing this problem, please email to support@compaq.com
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.