HPE Community
ProLiant Servers (ML,DL,SL)
1830032 Members
2181 Online
109998 Solutions
New Discussion

Re: Scsi error

 
Ayman Altounji
Valued Contributor

‎02-01-2001 04:00 PM

‎02-01-2001 04:00 PM

Scsi error

After installing an Adapted SCSI card AHA2940 into my ML530 I am getting an error in the TN event log saying "The device, \Device\ScsiPort5, did not respond within the time-out period. " It has an event ID of 9 and a source of "Cpqarry2" . Everything works fine but the messages are annoying. What do I need to do to get rid of them? The server has a 431 embedded controller handling the SO drives and a 4200 controller handling a storage works cabinet
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎02-12-2001 04:00 PM

‎02-12-2001 04:00 PM

Re: Scsi error

First - make sure the Adaptec's BIOS is disabled ("Ctrl A" during boot - change settings). Make sure it's NOT the primary in F10 setup (shouldn't be, but...). You may need to reinstall the array controller drivers as there may be some issue with the I/O address or... (kinda guessing here - haven't seen this).
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.