Setting up Multiprocessor support after Win2K is installed

[Ayman Altounji]

Configure the server hardware to the correct the "APIC Mode" settings. You must start System Configuration and press 'CTRL a' at the first menu after selecting F10 during boot. This activates "Advanced Mode". Then enter System Configuration itself and follow the prompts to complete a basic configuration load. Select to "Review" the settings and then pick "View/Edit Details" from the menu. Look down the list to find "APIC Mode". Press enter on this selection and select "Full Table, Mapped" (or "Full Table" if only choice, depends on specific system). Once this has been done, exit and save changes.

Then go into Computer Management, Device Manager, open up the "Computer" entry, right click on the entry under that (ACPI or something similar) and then select Properties. Go to the Driver tab and click Update Driver. Then pick "Next" and mark "Display list..." then "Next" again. Pick "Show all .." and pick the appropriate type from the list. For all current Compaq servers "MPS Multiprocessor" or "ACPI Multiprocessor" will work. For some much older models "Compaq SystemPro or Compatible" would work.

Regards,
Compaq Support Forum

[Ayman Altounji]

After I installed the Secondary Processor to the Prolant ML530 server, and configured the server as above steps, I found that there are some service cannot start properly. (e.g. Event ID: 7022 -- The Compaq Server Agents service hung on starting., Event ID: 7001 -- The Compaq Foundation Agents service depends on the Compaq Server Agents service which failed to start because of the following error: After starting, the service hung in a start-pending state.) The problem solved after I restore all settings
Should I reinstall any driver or program in Compaq Smart Start CD after configured for multi-processors in Windows2000?