Smart Array Controller driver Fix

[Ayman Altounji]

Called 800 OK Compaq, the fix is quick and easy! Run Smart Start Manual setup. Complete the array configuration. Create the SD diskettes from the Smart Start DC or obtain 2.20 rev a from Compass WEB site. From the 5 disk set, you will need disk 2. Boot from TN 4.0 ST DC. After Post completes, press F6 (hold if you want) during the "TN is inspecting your hardware". You will receive the same add additional mass storage dialog, add the Nit. Smart Array Controller. This will load the driver before starting the TN TS setup.

WORKS GREAT, Thanks.

[Ayman Altounji]

Just finished the Terminal Server install on the DL-380. The whole process works great as long as you press F6 right after post and BEFORE Terminal Server starts loading drivers! Sorry about the typo's in my original message.

[Ayman Altounji]

Yep - that's the way to do it...