Smart Start : Windows protection error

[Ayman Altounji]

I have installed the hardware for the ML370, but when I try to boot the server with Smart Start after a few smart start begin screens I always get the message : Windows protection error reboot the server. When I reboot the server the same message....
Somebody who can help me with this ?????

[Ayman Altounji]

What specific hardware did you install?

[Ayman Altounji]

When you are getting windows errors on the Smart Start CD program, it's a good idea to clear the NVRAM. Use SW1 on the system board and filp the #6 switch to the on position and power up the server. You will get a few errors on the next POST, which is normal. Run system configuration and then select save changes and exit. Power off the server and return the SW1 switch 6 to the off position. Then rerun the Smart Start CD.