ProLiant Servers (ML,DL,SL)
1823236 Members
3385 Online
109648 Solutions
New Discussion юеВ

SmartStart for Proliant 6000 Server

 
Jeremy Kraemer
Occasional Advisor

SmartStart for Proliant 6000 Server

Hello,
I was wondering if someone can tell me what is the lastest SmartStart for a Proliant 6000 Server and where I can get it?

Thanks!
10 REPLIES 10
AK85LP
Advisor

Re: SmartStart for Proliant 6000 Server

The last version that would work for this server was version 5.50. You can order it by calling 1-800-573-1099.

AK85LP
Jeremy Kraemer
Occasional Advisor

Re: SmartStart for Proliant 6000 Server

I Tried that version boots up with the logo and it just hangs there.
Rahul Sharma
Frequent Advisor

Re: SmartStart for Proliant 6000 Server

try bringing down your server to the minimum hardware. I mean take out extra storage attached to it take out the RIB board if any and then try.
Jeremy Kraemer
Occasional Advisor

Re: SmartStart for Proliant 6000 Server

No luck so for, Can you tell me where I can find the Array Configuration Utility floppy disk download?
Prashant (I am Back)
Honored Contributor

Re: SmartStart for Proliant 6000 Server

Jeremy Kraemer
Occasional Advisor

Re: SmartStart for Proliant 6000 Server

This is the frist Compaq server that I try to rebuild. I'm using the SmartStart CD Version 5.50. I have 3 9GB drive in port 1. I ran the CD but it hangs on the SmartStart logo it stays there for a few min. then the system reboots. I canot figure out why it's doing this.Can anyone help me.
Jeremy Kraemer
Occasional Advisor

Re: SmartStart for Proliant 6000 Server

Now I get a error 76
Jeremy Kraemer
Occasional Advisor

Re: SmartStart for Proliant 6000 Server

Well I found out what the problem was. It was the Cd rom drive. I changed it out now all is good. Thanks for the help!
Rahul Sharma
Frequent Advisor

Re: SmartStart for Proliant 6000 Server

Hi
I was having the same problems with my proliant 5500. Plz try the following.

Connect the server directly with a KB Mouse and monitor.(Disconnect from KVM switch)

Keep the minimum amount of memory what you need for your software installation.

The memory in the banks should be in descending order from 1 to 4 and so on. I mean to say the maxmimum amount of memory in bank one and then going down...

Take out rib card or any other card installed in the server and then see.
Jeremy Kraemer
Occasional Advisor

Re: SmartStart for Proliant 6000 Server

It was the CD Rom drive