HPE Community
ProLiant Servers (ML,DL,SL)
1830619 Members
2587 Online
110015 Solutions
New Discussion

SmartStart For Servers Generates ``Error Code: 59`` When No Hard Drives Are Attached To The Primary

 
Peter_437
New Member

‎03-01-2005 03:22 PM

‎03-01-2005 03:22 PM

SmartStart For Servers Generates ``Error Code: 59`` When No Hard Drives Are Attached To The Primary

Problem on Compaq Proliant ML350.

Error message: SmartStart For Servers Generates ``Error Code: 59`` When No Hard Drives Are Attached To The Primary Boot Controller

pls help. As I cannot proceed install Windows NT 4.0. What cause problem to be occur?
0 Kudos
Reply
2 REPLIES 2
Guido Koetter
Frequent Advisor

‎03-02-2005 04:05 AM

‎03-02-2005 04:05 AM

Re: SmartStart For Servers Generates ``Error Code: 59`` When No Hard Drives Are Attached To The Primary

Hello Peter,

whitch version of smart start you use and what kind of raid is installed??

I had this problem with older server too.

Greetings Guido
0 Kudos
Reply
Stephen Kebbell
Honored Contributor

‎03-02-2005 05:53 AM

‎03-02-2005 05:53 AM

Re: SmartStart For Servers Generates ``Error Code: 59`` When No Hard Drives Are Attached To The Primary


Hi,

this is usually caused by an incorrect boot controller order (e.g. onboard SCSI controller set before the Smart Array controller). You need to set that in System Configuration Utility, which you ususally do in an earlier part of SmartStart setup.

Regards,
Stephen
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.