- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- Re: Cannot Procede to install OS in Smart Start af...
ProLiant Servers - Netservers
1753776
Members
7284
Online
108799
Solutions
Forums
Categories
Company
Local Language
юдл
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
юдл
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-26-2008 01:21 PM
тАО08-26-2008 01:21 PM
Cannot Procede to install OS in Smart Start after array config
I am trying to use the Smart Start utility to configure the arrays and load the OS on a new DL320s server. I have configured the arrays but when I proceed to "Deploy" the OS, and click continue, nothing happens. Boot controllr disk size is showinf -1 mb in the Server Deployment Hardware Configuraton after configuring the arrays. Is there a wait time after array and logical drive configuration or have I missed a step?
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-01-2008 08:50 AM
тАО09-01-2008 08:50 AM
Re: Cannot Procede to install OS in Smart Start after array config
Timothy
Did you tried to configure the array by pressing ctrl+S while booting
Please check may be some times Array controller error
Did you tried to configure the array by pressing ctrl+S while booting
Please check may be some times Array controller error
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-16-2008 07:03 AM
тАО09-16-2008 07:03 AM
Re: Cannot Procede to install OS in Smart Start after array config
I just went to plan B, load the OS, which I did not want to do. Now I have to load the drivers from Windows. All went well withthat except for the network adapter configuration whaic I am working on now.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP