HPE Community
ProLiant Servers - Netservers
1850516 Members
2221 Online
104054 Solutions
New Discussion

Re: NetRaid Assistant

 
Louis-Pierre Gaudreau
Occasional Contributor

‎04-25-2002 10:44 AM

‎04-25-2002 10:44 AM

NetRaid Assistant

With two LH3 servers if I swap all hdd from one system to the other, will it work each time ?
In NetRaid Assistant in one case it didn't show me the menu to choice betwen view disk and NVRAM configuration, so it was not possible to make those hdd to work in the new system. Is it normal ?

Thanks
0 Kudos
Reply
1 REPLY 1
CA660377
Honored Contributor

‎04-25-2002 12:21 PM

‎04-25-2002 12:21 PM

Re: NetRaid Assistant

If you have previously swapped them back and forth, the config is still on the controller, so it will not prompt you for the config.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.