HPE Community
ProLiant Servers - Netservers
1845858 Members
4656 Online
110250 Solutions
New Discussion

NetRAID Getting =Reassignment error

 
Paul M. Michelena
Occasional Contributor

‎01-30-2003 04:23 PM

‎01-30-2003 04:23 PM

NetRAID Getting =Reassignment error

One of my LC2000R's has had a drive failure. It appears as if the hot swappable drive did not failover auomatically even though it is set to do so. When I put a new drive in and then try to rebuild it I recieve a =Reassignment error at around 50% of the rebuild then it fails. I am currently sending another drive out to swap. Any ideas......
0 Kudos
Reply
1 REPLY 1
CA660377
Honored Contributor

‎01-31-2003 10:46 AM

‎01-31-2003 10:46 AM

Re: NetRAID Getting =Reassignment error

How often do you perform consistancy checks on the RAID array? Usually if a rebuild fails, there is corruption in the array stripes.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.