ProLiant Servers - Netservers
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant DL320 G1 supported P3 Processors?

 
Highlighted
Frequent Advisor

Proliant DL320 G1 supported P3 Processors?

I have a DL320 with an 800Mhz P3 (Coppermine? 1.7V). Does the DL320 support the Tualatin processors?

Thanks

Andy
4 REPLIES 4
Highlighted
Honored Contributor

Re: Proliant DL320 G1 supported P3 Processors?

If I'm not wrong: Tualatin Processor started from 1.13GHz and lover voltage.
Your system board support only Coppermine 800, 866, 933 and 1GHz
Highlighted
Frequent Advisor

Re: Proliant DL320 G1 supported P3 Processors?

Has there been 2 revisions of the DL320 P3 boards since the support/download page for the DL320 states 'ProLiant DL320 (800-1.53GHz', and I didn't think there was a Coppermine that went to these speeds?
I know there are motherboards that auto-detect the processor type - is it likely the DL320 is one of these?

Andy
Highlighted
Honored Contributor

Re: Proliant DL320 G1 supported P3 Processors?

System Board 800 - 1GHz 207723-001
System Board 1.13 - 1.26 GHz 260142-001
Highlighted
Frequent Advisor

Re: Proliant DL320 G1 supported P3 Processors?

Thanks for the reply. I managed to find this out after a bit more digging. Although there was never officially a G2 DL320 there were 2 revisions of the system board - as you state one for the Coppermine processors and one for the Tualatin processors.

Ah well, I have a Tualatin 1.4Ghz P3 to put on eBay......

Andy