HPE Community
ProLiant Servers - Netservers
1830150 Members
14305 Online
109999 Solutions
New Discussion

smart array controller 3200

 
CA1191553
Occasional Advisor

‎10-07-2004 07:41 AM

‎10-07-2004 07:41 AM

smart array controller 3200

I have a proliant 1850R server and using a smart array 3200 controller. It recognizes the controller but then says to run array config utility. I hit f1 and I get a non-system disk error. It says to use the array configuration utility but the directions seem to say you need to run this in windows I can even get there. Anybody have any thoughts or ideas on what I should do besides blow it up:-)
0 Kudos
Reply
1 REPLY 1
Tarek Kawach
Honored Contributor

‎10-07-2004 07:53 AM

‎10-07-2004 07:53 AM

Re: smart array controller 3200

Hi Jeffrey:

You need to use the Array configuration utility from smart start 5.50 or under. to configure the array on the SA3200.


http://h18004.www1.hp.com/support/files/server/us/subscription/PSM_subscription.html

- that is the only way to create logical drive on that controller.

Best regards,

Tarek.
Hey, look a light at the end of the tunnel.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.