HPE Community
ProLiant Servers - Netservers
1850603 Members
3115 Online
104054 Solutions
New Discussion

SSH with LO100i version 1.21 on DL145 G2

 
BR811540
Occasional Contributor

‎10-13-2005 03:38 AM

‎10-13-2005 03:38 AM

SSH with LO100i version 1.21 on DL145 G2

How do I setup ssh with the 1.21 version?
I tried to follow the instructions in the User Guide but I failed to make it work. I just get a
"Initiating Download..." and the I got disconnected.

It might be me but is 1.21 much slower than previous versions? Especially when you are trying to access the BIOS through the LO.
0 Kudos
Reply
2 REPLIES 2
Tim Cutts
New Member

‎01-18-2006 12:24 AM

‎01-18-2006 12:24 AM

Re: SSH with LO100i version 1.21 on DL145 G2

I've been having difficulty with this also. I can't even get as far as loading the SSH key, since it rejects the syntax shown in the manual:

/./map1/firmware/> load -source //172.17.21.1/sshkey -oemhpfileType key
Invalid parameters.

Did you at least get that bit to work?
0 Kudos
Reply
BR811540
Occasional Contributor

‎01-19-2006 08:49 PM

‎01-19-2006 08:49 PM

Re: SSH with LO100i version 1.21 on DL145 G2

I think I managed to install the key, but I can't remember how I did it. I haven't had the need of using the LO for a while...
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.