pager notification to mobile phone

[Benneweg]

Hello,

I want to send an SMS (Short Message Service) via Pager Notification (CIM 7 SP2/ OS: W2k) to my mobile phone in Germany (Deutsche Telekom). But I don´t want to use some extra software.

I´ve already tried this:
phone number: provider´s gateway
PIN number: my mobile phone number

But I always get this error mesage in the pager status:
Opening COM3... Successful
--> Sending to modem: ATE0V1Q0
<-- Reply from modem: ATE0V1Q0


OK
--> Sending to modem: ATE0V1
<-- Reply from modem: OK
--> Sending to modem: ATE0V1Q0
<-- Reply from modem: OK
--> Sending to modem: AT&C1&D2
<-- Reply from modem: OK
--> Sending to modem: AT&M0
<-- Reply from modem: OK
--> Sending to modem: AT&K0
<-- Reply from modem: OK

Sending Alphanumeric Page to User
--> Sending to modem: ATDT0,01712521002
<-- Reply from modem:
<-- Reply from modem: CONNECT

Connected to pager service modem
--> Sending to modem:
--> Sending to modem:
--> Sending to modem:
--> Sending to modem:
--> Sending to modem:

Error: Timeout waiting for the pager service to start the TAP protocol


Is there any possibility to get it sta

[Jadrice Toussaint]

If your phone has email capability, why not just send an SMS style email to it?

[David Claypool]

You should confirm that your provider supports TAP (Telelocator Alphanumeric Protocol). The paging applet in IM7 assumes TAP. I think this is probably the problem since you are connecting and negotiating the connection but when the TAP stuff kicks in, you are getting stuck.

If your provider doesn't use TAP, then an email gateway is your alternative.

[Benneweg]

My provider supports the TAP-protocol. Do I have to use special characters in front of or behind my mobile phone number?