How to Disable ILO on DL360 G5

[Dan B.]

Is there a procedure to disable ILO on DL360 G5 so HP SIM does not see it as major? Have tried removing Remote Insight Information through control panel. This worked on earlier versions of DL360's but not on G5's. Can this be done without having to disable it in BIOS and then have to go through the reset security dip switch procedure if I ever wanted to re-enable it? Thanks Dan

[Raghuarch]

Did you try:

Disable Level of Data Returned: in Configure Insight Manager Integration.

This setting is in Administration TAB under Management.

Then delete the iLO from HPSIM server.

in the future discoveries HPSIM doesn't recognize it as iLO.

[Raghuarch]

Did you try:

Disable Level of Data Returned: in Configure Insight Manager Integration in iLO.

This setting is in Administration TAB under Management.

Then delete the iLO from HPSIM server.

in the future discoveries HPSIM doesn't recognize it as iLO.

[Dan B.]

Having difficulty locating these tabs. Running HP SIM 5.2 and Server Support Pack 8.0. Not sure where to locate "Level of Data Returned". Thanks.

[Raghuarch]

The TAB is Under in iLO.
Administration: Select Management

[Raghuarch]

The TAB is not in HPSIM

[Dan B.]

OK, the management tab is on the ILO interface itself. Disabled Level of Data Returned, removed "Remote Insight Information" from server agents, rebooted, removed/added server to HP SIM. Management Processor status still shows "nic in operation but disconnected" and SIM shows major. You mention deleting the ILO, how do you delete just the ILO?

[Raghuarch]

Select the iLO in HPSIM All Systems.
And Click on Delete or remove button.

[Dan B.]

My apologies but under All systems I only see the server itself. There appears to be no provision for just deleting an ILO.

[Dan B.]

Here's a solution:
Change SMH Data Source from WEBM to SNMP.
Remove WBEM Provider software from Add/Remove Programs. Re-run Identify.