HPE Community
Server Management - Remote Server Management
1847839 Members
5769 Online
104021 Solutions
New Discussion

RILO2 Board in DL380G2 will not Boot from virtuell CD

 
Hense, Klaus
Valued Contributor

‎03-16-2005 09:48 PM

‎03-16-2005 09:48 PM

RILO2 Board in DL380G2 will not Boot from virtuell CD

I have DL380G2 Servers with RILO2 Boards. I Can not boot from the virtuell CD (Smartstart). Booting from Floppy is OK.
All Bios and Firmware are new.

Is this a Failure or is it not supportet?
klhe
0 Kudos
Reply
2 REPLIES 2
acartes
Honored Contributor

‎03-25-2005 02:48 AM

‎03-25-2005 02:48 AM

Re: RILO2 Board in DL380G2 will not Boot from virtuell CD

Verify that you have the 30-pin RILOE II cable properly installed. This carries the signals that enable virtual CD.
0 Kudos
Reply
Andrzej Kowalik
Honored Contributor

‎03-25-2005 03:50 AM

‎03-25-2005 03:50 AM

Re: RILO2 Board in DL380G2 will not Boot from virtuell CD

Acartes,
look at thread with the same name ;-)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.