Update ILO Amplifier Pack to 1.80: High CPU Usage - ESX

[Styx2]

Thank you

[--Matt--]

Update installed.  CPU back to normal - thanks.

Matt

[UlrichThomas]

@--Matt-- 

Did the update fixes your ILO appliance?

30 Minutes after installing the update I saw a high cpu load again, now about 25% but not 80% .

[Birchi]

Hi All,

i'm not able to download the bin file.. After I click on "Download", the following error message appears. Do you have any idea what the problem could be?

Thank you and BR

Manuel

[UlrichThomas]

@Birchi I clicked directly on the unterlined link of file. That started the download right now.

[--Matt--]

Seeing the same 25% utilization...  Suppose it's better than 90%...

[UlrichThomas]

@ksram  please advice your dev team thats the update didn't fix the whole problem.

@--Matt--  of course 25% is better than 80%, but the previous version didn't have such a high cpu load at all.

At 07:30 I installed the 1.81. At 12:30 I manually rebooted the appliance.

[Styx2]

Thank you

[ksram]

Hi @Birchi ,

Please try to download again now / use different broswers / Clear Cache.

I just tried to download the file and it appears to be downloading fine now.

Thank you

RamKS

[ksram]

Great!

If you feel this was helpful please click the KUDOS! Thumbs below!

[ksram]

Hi @--Matt-- ,

Let me check this, and share update

Also may I know what the Utlization before the update? Was it lesser than 10%?

Thank you

RamKS

[--Matt--]

Hi @ksram ,

This was a fresh 1st deployment of the Amplifier pack, so I have no benchmark for pre 1.80.  It is a very small deployment monitoring only 6 servers.

Thanks,

Matthew

[UlrichThomas]

@ksram before the update to 1.80 the load was less than 1%.

[Panthro79]

v1.80 not only broke CPU usage but also stopped internet access via the proxy too.  Was this update even tested?

[Panthro79]

Thankfully v1.81 has fixed all the issues that v1.80 caused.

[MarioJAF]

I updated today to 1.81. For the first hour the cpu load was back to normal, but after an hour it raised to 25% (1 core out of 4).
This is better than 80% load but something ist still putting unnecessary load on the cpu. Please investigate further on this issue.

[perbengtsson]

My Hyper-V appliance went down from 50% to around 1% after upgrade to 1.81 and it has stayed there for four hours now. I even rebooted the appliance once to see that it didn't start again after the reboot.

Everything's looking fine here so far.

[sdonnelly41]

About an hour in after the update and CPU went from over 7GHz down to 83MHz. Hoping this trend continues.

[--Matt--]

After installing 1.81 my CPU usage dropped to 25%.  I did a bit of fiddling with the settings and got the CPU to 0.6%

See if this works for you:

Under "Configuration and Settings" - "General Settings" - "Anonymous Usage Data Collection" -- uncheck the "I agree to send anonymous usage data to HPE"

[--Matt--]

[MarioJAF]

lol ... disabling "I agree to send anonymous usage data to HPE" also dropped my cpu load from 25% to 0%

thx Mat!

[sdonnelly41]

Well my CPU usage spiked and then I made this change and what do you know the usage went down to 62MHz! Thanks man!