HPE Community
Server Management - Systems Insight Manager
1848135 Members
9417 Online
104022 Solutions
New Discussion

Enclosure removed (22003) / Enclosure inserted (22004)

 
James Lackey
Occasional Contributor

‎11-04-2008 12:03 PM

‎11-04-2008 12:03 PM

Enclosure removed (22003) / Enclosure inserted (22004)

I'm getting several of these errors per minute (3-8 events per minute) through the day, all from the same enclosure. I didn't see these events prior to a decision to wipe our SIM 5.1 install and start fresh with SIM 5.2.

I'm trying to figure out if I've got a physical hardware issue (jiggling against a physical sensor?) or a software/firmware issue. Preferably without disturbing service for any of the blades...
0 Kudos
Reply
1 REPLY 1
Rob Buxton
Honored Contributor

‎11-04-2008 07:30 PM

‎11-04-2008 07:30 PM

Re: Enclosure removed (22003) / Enclosure inserted (22004)

HPSIM wouldn't normally generate events without receiving a trap.
You could just redirect the snmp trap send from the enclosure to somewhere else and see if they stop. That would at least show HPSIM wasn't generating the events on it's own - unless they continued!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.